Quartz sand dryer three-drum dryer

Structural composition:

• Drum part:

It is composed of three concentric cylinders of different diameters. The inner cylinder, middle cylinder and outer cylinder cooperate with each other. The inner cylinder performs preliminary heat exchange and drying, the middle cylinder further enhances the drying effect, and the outer cylinder plays the role of heat preservation and auxiliary drying.

• Transmission device:

including motor, reducer, support wheel, wheel belt, etc. The motor provides power, drives the support wheel to rotate through the reducer, and the friction between the support wheel and the wheel belt causes the cylinder to rotate, ensuring that the material continues to roll and move in the cylinder.

• Feeding device:

The quartz sand to be dried is transported to the dryer, and the stability and uniformity of the feed need to be ensured.

• Discharging device:

It is used to discharge the dried quartz sand, and it has good sealing to prevent hot gas leakage and dust overflow.

• Heat source system:

Provides heat for the drying process. Common heat sources include coal, natural gas, biomass particles, etc.

• Lifting plate device:

Lifting plates with different angles and spacings are provided in the cylinder, so that the quartz sand can be evenly dispersed and turned in the cylinder, and fully contact with the hot air flow.

• Dust removal system:

collects and processes dust generated during the drying process to reduce environmental pollution.

• Working principle:

wet quartz sand enters the inner drum from the feeding device, is continuously picked up and scattered by the shovel in the inner drum, and undergoes preliminary heat exchange with the hot air flow from the heat source system to achieve downstream drying and initially remove most of the moisture. Then the quartz sand enters the middle drum for countercurrent drying, where the material is repeatedly lifted in the middle drum to extend the drying time. Finally, the quartz sand falls into the outer drum, where it is further dried and discharged from the discharging device.

Advantages and characteristics:

High efficiency and energy saving:

• High thermal efficiency:

The three-drum structure increases the contact area and heat exchange time between the material and the hot air flow. The heat emitted by the inner drum can be partially absorbed and utilized by the middle drum and the outer drum, reducing heat loss. The thermal efficiency can be greatly improved compared to the single-drum dryer, and the energy-saving effect is significant.

• Strong fuel adaptability:

It can adapt to a variety of fuels. Enterprises can flexibly choose according to local fuel resources and costs to reduce fuel costs.

Good drying effect:

• The material is dried evenly:

The unique cylinder structure and lifting plate design enable the quartz sand to be evenly dispersed and turned in the dryer, avoiding material accumulation and uneven drying, and ensuring that the moisture content of the quartz sand is uniform after drying.

• High material quality:

The temperature and heat are evenly distributed during the drying process, and the quartz sand will not deteriorate or discolor due to local overheating, which well guarantees the quality of the quartz sand.

Compact structure:

• Small footprint:

The cylinder structure of the three-cylinder dryer is compact, and the footprint is only about half of that of the single-cylinder dryer with the same output, saving a lot of site space, which is very suitable for enterprises with limited space.

• Easy installation:

The overall structure is relatively simple, the installation process is not complicated, and no complex infrastructure and large-scale lifting equipment are required, which can shorten the installation cycle and reduce the installation cost.

Reliable operation:

• Small equipment wear:

The friction between the quartz sand and the cylinder and lifting plate during the drying process is relatively small, which reduces the wear of the equipment and extends the service life of the equipment.

• Simple operation and maintenance:

The degree of automation is high, the operation is simple and convenient, and only a small number of operators are required to complete the production process. Daily maintenance work is relatively simple and the maintenance cost is low.

• Good environmental performance:

Equipped with advanced dust removal system, it can effectively collect and process the dust generated during the drying process, reduce pollution to the environment, and meet environmental protection requirements.